The Experimental Investigation of Using Waste Glass Powder as Partial Cement Replacement in Concrete

Authors

  • HEDAYAT ULLAH SAFI Author
  • MOHAMMAD MUKHLIS BEHSOODI Author
  • AMANULLAH FAQIRI Author

DOI:

https://doi.org/10.68924/jxgr2639

Keywords:

Cement Replacement, Concrete, Mechanical Strengths, Waste Glass Powder (WGP), Workability

Abstract

Cement production is renowned for its substantial contribution to carbon dioxide emissions, whereas the disposal of glass waste presents intricate challenges. The presence of Silicon and Aluminum Oxides in both cement and glass facilitates a Pozzolanic Reaction, culminating in the formation of Silica gel upon their interaction with Calcium Hydroxide in the presence of moisture. Silica gel plays a crucial role in binding aggregates, fine aggregates, and sand in concrete. Achieving the desired Pozzolanic reaction necessitates the glass powder to be finely ground to particles below 75 µm. This study delves into the exploration of waste glass powder utilization as a partial replacement for cement in concrete production. Experimental investigations comprehended the substitution of cement with glass powder at varying proportions (10%, 15%, 17.5%, and 20%) in cubic, cylindrical, and prismatic samples. Subsequently, compressive strength, split tensile strength, and flexural strength tests were conducted following the curing of samples for 7, 14, and 28 days. The results revealed that the optimal replacement level of 17.5% exhibited superior compressive, split tensile, and flexural strengths across all curing periods. However, it was observed that the workability of concrete diminished with the increasing percentage of glass powder. While the replacements of 10% and 15% enhanced strength in comparison to the control (0%), the substitution rate of 20% led to a reduction in compressive, split tensile, and flexural strengths, consequently compromising both the workability and mechanical strengths of the concrete.

Author Biographies

  • HEDAYAT ULLAH SAFI

    Hedayat Ullah Safi received the BSc. degree in Civil Engineering from the National Defense University in 2014 and completed his MSc. degree in Structural Engineering (Civil and Industrial Construction) in 2022, from Kabul Polytechnic University, Kabul, Afghanistan. Currently, he is working as a teaching assistant and his areas of research include sustainable development, building construction materials, concrete and steel structure design.

  • MOHAMMAD MUKHLIS BEHSOODI

    Mohammad Mukhlis Behsoodi received the BSc. Degree in Civil Engineering from Alfalah University in 2018 and completed his MSc. degree in Urban Infrastructure Engineering from the National Institute of Urban Infrastructure Planning, University of Engineering and Technology, Peshawar, Pakistan in 2023. Currently, he is working as a VC. Academics of Spinghar Institute of Higher Education and Visiting Lecturer in Civil Engineering Department of Alfalah University in Nangarhar Afghanistan. His area of research includes sustainable development, SDGs, urban infrastructures, construction materials, and construction technology.

  • AMANULLAH FAQIRI

    Amanullah Faqiri is a professor in the Department of Building Construction, Faculty of Civil Engineering, Kabul Polytechnic University. He graduated from Kabul Polytechnic University with a master's degree in civil and industrial buildings in 1371 and received a doctorate in civil engineering from India in 1396. His research areas are research methods, leadership and management, contract management, and concrete properties analysis.

Downloads

Published

2026-08-22

Issue

Section

Articles

How to Cite

The Experimental Investigation of Using Waste Glass Powder as Partial Cement Replacement in Concrete. (2026). Kabul Polytechnic University International Journal of Engineering & Technology, 4(1), 121-134. https://doi.org/10.68924/jxgr2639

Similar Articles

31-40 of 42

You may also start an advanced similarity search for this article.